Thought it was time to start a new thread since the other was getting to long.
You guy once again have dazzled me with your insight and knowledge. Many thanks.
I finally now see the big picture as to what I need to be doing to make these cabinets functional with the amps that I have. (1) buy 4-16 ohm matching woofers that I can afford;
(2) since cabinet is currently empty, turn speaker board upside down and close top opening until horns
can be found;
(3) when horns are found, get cross-over board.......any suggestions as which one to get....specifics please.
(4) install on/off switch for horns.
So there is no way of using just one speaker cabinet with my amps then for bass only? A separate wiring circuit internally where one speaker would run left side and other the right. I realize that total load would be 8 ohms and power would be decreased but would make functional. Would that be possible?
Again, thanks. You guys have made my dream a reality.