Home » VintageKustom.com » Repairing Kustom Amps » Wiring Diagram for PA columns with 6 16 ohms Kustom Speakers (How do I wire the PA columns for the correct load?)
Wiring Diagram for PA columns with 6 16 ohms Kustom Speakers [message #26159] Mon, 22 May 2017 16:00 Go to previous message
MRBASSMANTROUT is currently offline  MRBASSMANTROUT
Messages: 2
Registered: May 2017
Location: KCK
Junior Member
I recently purchase two Cascade covered PA columns. When I opened the columns I found each have 6, 8 inch, 16 ohm speakers. I have to rewire them because part of the wiring is missing. My question is how to I wire the columns up to get the correct factory load? And is there a wiring diagram for me to follow? Thanks in advance for any input you might have.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Kasino U100-P - Reverb
Next Topic: Frankenstein Head replace electrolytic captor on reverb board
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Apr #d 04:42:19 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.9.