VintageKustom.com: Comment Board

Re: My new cab [message #26458 is a reply to message #26450]

Sat, 13 January 2018 06:24

stevem
Messages: 4733
Registered: June 2004
Location: NY

Senior Member

Some corrections first.
The 130 watts labeled on the rear of the amp is the amps RMS output power and those are the output jacks , not the input jacks like you posted, the 400 watts labeled on the rear is how much power the amp draws from the wall outlet to produce that 130 watts.

I would recommend to you a Eminence brand driver that you can get from parts express.
It's part number 290-414 and cost 80 bucks each.

These are the only true Bass drivers I could find who's Vas spec is close to working with that size cabinet, all the other Bass drivers I found need a far far bigger cabinet!

Another option for you would be if your blown drivers are the square magnet CTS bass drivers you could send them out to Weber and get them re- coned, but with a higher power handling voice coil then what they where made with.

Cost wise once you figure in the shipping you may only save 10 bucks or so going this route.

[Updated on: Sat, 13 January 2018 06:27]

Report message to a moderator