jammy5152 Messages: 61 Registered: May 2018 Location: Georgia
Member
I just recenlty got a Kustom X Monural Power Amp 130 rms @ 8 ohm and when I got it hooked up through a mixer and microphone, it started good but after a while it started with a soft hiss and then gradually got louder until the hiss was LOUD and unbearable so I just turned it off...
Using freeze spray to try to isolate it did not do much good in locating a bad component...
Would like someone to given me ideas in repaing it
It uses a 5065 board which I was told
Thanks