Home » VintageKustom.com » Repairing Kustom Amps » K200A-1 Power Amp Rescue Needed (Serial Number 20466)
Re: K200A-1 Power Amp Rescue Needed [message #27281 is a reply to message #27270] Thu, 25 April 2019 12:27 Go to previous messageGo to previous message
thetragichero is currently offline  thetragichero
Messages: 33
Registered: April 2019
Member
update: i couldn't wait so i tried it out. sounds a bit hissy (who'da thunk with all those carbon comp resistors, right?), output power not nearly what i would've expected (it's not quiet but i expected louder... the 100watt solid state traynor pa i converted to a guitar amp is LOUD)
i will admit that the bias diode is not attached to the clip just yet, because i am waiting on a shipment of thermal grease to come in the next few days, so that could be part of the problem
i am getting 40V on r705 (i want to say it's the end connected to r710 but maybe i was looking at something upside down...) and mv on the other end, whereas the schematic says 60V at the junction of the emitters of q701 and q702
i didn't put the knobs back on so i got some crackling touching the pot shafts. i will clean the pots again

received some 2n3055 in the mail today i may chuck in just for S&Gs once the thermal grease is here. the power transistors tested fine but these were a couple bucks on ebay so no harm no foul (and if all of the power transistors i have are good, then i guess i will have to build an amp Wink)

okay now back to real work lol
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Challenger Reverb Problem
Next Topic: Kustom 100 blowing fuse
Goto Forum:
  


Current Time: Sat Apr #d 17:51:39 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.9.