Home » VintageKustom.com » Repairing Kustom Amps » K200A-1 Power Amp Rescue Needed (Serial Number 20466)
Re: K200A-1 Power Amp Rescue Needed [message #27287 is a reply to message #27251] Thu, 25 April 2019 15:21 Go to previous messageGo to previous message
chicagobill
Messages: 2005
Registered: April 2003
Senior Member
I use 2N3055's as well. I usually buy them 10 at a time and gain match them when I get them.

When working on any of these amps, I leave the compensation diode loose from the clip until I'm done removing and replacing the boards, that way the leads will not be flexed any more than necessary. I worry more that the diode lead will break and causing the amp to go into meltdown mode.

I should have guessed that the outputs were mixed and matched from the description of the 24 volt regulator board!

I have nothing against NTE parts, but I hate to pay all that money for them when it isn't needed.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Challenger Reverb Problem
Next Topic: Kustom 100 blowing fuse
Goto Forum:
  


Current Time: Sat Apr #d 22:26:21 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.9.