Home » VintageKustom.com » Repairing Kustom Amps » Troubleshooting a 250 model 1 Bass amp (250 Model 1 needs help!)
Re: Troubleshooting a 250 model 1 Bass amp [message #27396 is a reply to message #27393] Tue, 25 June 2019 17:19 Go to previous messageGo to previous message
Byteviolator is currently offline  Byteviolator
Messages: 13
Registered: June 2019
Junior Member
Hi Steve,

Thanks for your input. I may have vastly overestimated my troubleshooting skills!

I don't know if my last message was sent so..
1) The two main filters are an easily reversible fix. They are still in place
2) Should I start with Q1 on the 5065 or start testing the power transistors Q10 - Q13 first?
3) With the 3 wire connector plugged in to 5065 I measure about 43mV on the output jack when the amp is on

I've also replaced the power cable with a 3 pronged cause I was getting zapped while holding the chassis and unplugging the input jack.

Thanks again for your help
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Kustom III lead pc board 5065 rev2
Next Topic: Kasino u100-p (Club) and u200-p (Concert) repair
Goto Forum:
  


Current Time: Sat Apr #d 03:09:27 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.9.