Bass filter for cabinet [message #29131] |
Sat, 14 October 2023 12:34 |
BC
Messages: 583 Registered: March 2000 Location: Kentucky
|
Senior Member |
|
|
I recently acquired a 1x15+2x10 cabinet from the Selectone series 200 amps. The KEI 15 was toast but, the 10s work well. I had a 16 ohm JBL D140 in my spares so it replaced the KEI. I would like to use this for bass. How do I construct a filter to prevent the low tones from beating the 10s to death. I want to run the 15 full range. Thanks! BC
|
|
|
Re: Bass filter for cabinet [message #29132 is a reply to message #29131] |
Mon, 16 October 2023 06:02 |
stevem
Messages: 4776 Registered: June 2004 Location: NY
|
Senior Member |
|
|
I will get back to you later today when I gig out my notes on this subject.
Off the top of my head I want to say that the cross over Kustom used for the cabinets that had horns was a 5 mfd 50 volt electrolytic cap, although it could be a non polarized cap also .
[Updated on: Mon, 16 October 2023 06:04] Report message to a moderator
|
|
|
|
Re: Bass filter for cabinet [message #29136 is a reply to message #29134] |
Tue, 17 October 2023 17:44 |
BC
Messages: 583 Registered: March 2000 Location: Kentucky
|
Senior Member |
|
|
They are wired parallel and the 15 was parallel to them. Not sure about ohms. I think they are Jensens by the numbers. Old and faded. I know the KEI 15 was a 16 ohm. I will research and get back to you
|
|
|
|
|
|
|