VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » Classified Ads » Wanted » Wanted: Ports (Replacement ports for 2x12 cab)
Show: Today's Messages :: Polls :: Message Navigator
Switch to threaded view of this topic Create a new topic Submit Reply
Wanted: Ports [message #29246] Sun, 19 May 2024 21:27 Go to next message
Kustom14 is currently offline  Kustom14
Messages: 8
Registered: May 2024
Location: Batavia, Ohio
Junior Member
Any suggestions as to where I can get a couple of replacement ports? I recently picked up a 2x12 and one of the ports is chipped.
Re: Wanted: Ports [message #29247 is a reply to message #29246] Mon, 20 May 2024 06:00 Go to previous messageGo to next message
stevem is currently offline  stevem
Messages: 4777
Registered: June 2004
Location: NY
Senior Member
Maybe a member has a spare used one, but I have repaired them just like doing body work on a car and then sent them out to get the plastic chrome put back on.

But now there is another way to go that simulates the chrome great.
It's a chrome marker that leaves a tuff mirror like finish .

In regards to your post here you have to make 5 that I have to approve before yours will just go up to the board when you log in.

Also note that this site does not accept pictures, there's a Kustom site on FB that does.
Re: Wanted: Ports [message #29248 is a reply to message #29247] Mon, 20 May 2024 09:25 Go to previous messageGo to next message
Kustom14 is currently offline  Kustom14
Messages: 8
Registered: May 2024
Location: Batavia, Ohio
Junior Member
Thanks for the advice. Actually I am a returning member who hasn't been on in a while, but I couldn't seem to access my old account.

I can't repair the damaged port on this one, because a piece of the outer flange is missing. And sadly, I had a couple of ports for years, never used them, and I *think* I may have trashed them in a recent move.

I'm also in the same boat as another poster who asked about changing the background or font colors, because I'm getting white letters against a light-gray background, and I can't find where to change that up.
Re: Wanted: Ports [message #29249 is a reply to message #29246] Tue, 21 May 2024 05:42 Go to previous message
stevem is currently offline  stevem
Messages: 4777
Registered: June 2004
Location: NY
Senior Member
You might need to concider changing both port tubes over 260-404 from Parts Express.
  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Power module KPN 200=0167
Next Topic: Blue K250 Power Button Needed
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Fri Dec 13 00:47:01 EST 2024