VintageKustom.com: Repairing Kustom Amps » PC402A and 402B/ clipper/ boost

Home » VintageKustom.com » Repairing Kustom Amps » PC402A and 402B/ clipper/ boost

Show: Today's Messages :: Polls :: Message Navigator

PC402A and 402B/ clipper/ boost [message #6590]

Sat, 28 January 2006 20:35

kustomise
Messages: 37
Registered: January 2005
Location: Redding California

Member

I need a untampered with PC402A and PC402B boards for a K200A series head. This is the double selective boost and harmonic clipper board. Does anybody know if a B series boost/clipper pc board could be wired up to an A series? If so, that could work too. These boards on my A3 were toasted before I bought it due to a soldering iron in the wrong hands. All effects work through the left channel only on A heads and that channels power is routed through the effects board.

Kustom Rules!

Report message to a moderator

Re: PC402A and 402B/ clipper/ boost [message #6597 is a reply to message #6590]

Tue, 31 January 2006 08:23

stevem
Messages: 4886
Registered: June 2004
Location: NY

Senior Member

I have never seen the inside of a A model head, But if it is set up like a B head wire wise it would be like this.
#1
preamp positive and negative power supply of + 8 volts and -8 volts feed to each preamp board.( red and green wires in B model)
#2
A blue wire bringing the output signal for each preamp to the driver board.
If your amp is like this, than YES you can use the B SERISE boards in your A model if the control spacing holes on the front panel are the same.

Report message to a moderator

Previous Topic:	Question: Checking voltages on Challenger
Next Topic:	metal face 150 /250 tips

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Tue Jul 14 14:37:41 EDT 2026