VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Repairing Kustom Amps » Kustom 100 PA head CHASSIS SCREW SIZE
Show: Today's Messages :: Polls :: Message Navigator
Switch to threaded view of this topic Create a new topic Submit Reply
Kustom 100 PA head CHASSIS SCREW SIZE [message #29342] Thu, 26 September 2024 05:47 Go to next message
backlineguy is currently offline  backlineguy
Messages: 20
Registered: November 2023
Junior Member
Hello all,

I just acquired a Kustom 100 4-channel PA head in very good condition ( the tuck and roll is beautiful Charcoal), but the chassis screws are not the correct size...apparently whomever replaced the power cord with a grounded plug either lost them, or they were wrong to begin with...anyone out there know the correct screws needed to secure this sucker?
Thank you in advance for your help!
Re: Kustom 100 PA head CHASSIS SCREW SIZE [message #29345 is a reply to message #29342] Sat, 28 September 2024 21:07 Go to previous messageGo to next message
chicagobill
Messages: 2006
Registered: April 2003
Senior Member
Standard K100 heads use 10-32 x 1 1/4" Phillips head screws with a flat washer.
Re: Kustom 100 PA head CHASSIS SCREW SIZE [message #29347 is a reply to message #29345] Tue, 01 October 2024 09:24 Go to previous message
backlineguy is currently offline  backlineguy
Messages: 20
Registered: November 2023
Junior Member
Thanks Chicagobill!
  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Repairing Kustom K100-1
Next Topic: Older 212 cabinet??
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sun Nov 10 10:38:03 EST 2024